Premium Vanity Units With Drawers For Bathroom

DIY Vanity Units with Drawers for Bathroom

Vanity units with drawers for bathroom – Bathroom vanity to look like the furniture is in the cry, but can be quite expensive. To save money, make use of old kitchen cabinets or vanity by adding piping to tops. Paying for a device at your local home improvement store can cost anywhere from a few hundred dollars to a few thousand dollars depending on the type and quality. Re purposing flea market find or grandmother’s old donor not only saves money but also our landfills. Remove and disassemble the top and all the boxes. If the cabinet has drawers, it will be necessary to disassemble the top box completely. Before this box will be used later.

Apply water resistant surface to the vanity units with drawers for bathroom. If you are installing a new sink and faucet, use a hole or template provided by the manufacturers to reduce your holes. Measuring plumbing comes out of the wall. You will probably have a 1-1 / 4 inch to 2 inch drain line and two lines of water with stops coming out. You have to cut holes in the back of the platter for plumbing to walk. If you’re like me, you can cut individual holes to mess up with, if you’re like my husband, a big hole will do (no one will see it anyway).

Move the vanity units with drawers for bathroom up against the wall, plumbing through the hole(s). Place the sink and mixer in recess. Then connect the plumbing (sewers and water lines). Drive around the sink and faucet base, This will keep any water flowing out of the bottom of the cabinet area. Remember that the box you disassemble? You will now glue the face of this box in place. This provides space for your plumbing. Put the remaining boxes (or attaché cabinet doors) and the job is done!

Leave a Reply